I just set up my second ESS with a new Windows 10 PC . The PC is a refurbished HP (basically new) I got off ebay for 85 bucks. I run Mach 3 and I'm trying to migrate to Mach 4, but I know Mach 3 so well its hard to invest all the time into Mach 4.
Anyway, it runs flawlessly, took less than 2 hours to get it all downloaded and running.
Results 1 to 20 of 30
Threaded View
-
02-20-2022, 05:16 PM #13
Registered
- Join Date
- Feb 2005
- Posts
- 750
Re: pc is dying, is it time for mach 4
Halfnutz
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With QuoteSimilar Threads
-
Signs of a dying tube.
By Nickwit in forum Laser Engraving / Cutting Machine General TopicsReplies: 10Last Post: 11-06-2014, 03:54 AM -
DXF in Mach 3 - same problem every time...
By JackWilliam in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 09-06-2013, 09:29 PM -
Time units in Mach
By panozeng in forum Waterjet General TopicsReplies: 2Last Post: 12-07-2010, 03:29 AM -
Mach 3 m2home is lit all the time
By sweetwood in forum Machines running Mach SoftwareReplies: 19Last Post: 07-09-2010, 06:21 PM -
Elapsed time in Mach 3
By Revtech in forum Mach MillReplies: 3Last Post: 10-20-2006, 02:03 PM
Tags for this Thread
Posting Permissions
