[rockrunner86]

I have a 1996 Daewoo Puma 8S with the Fanuc 0T-C control On the machine control panel (not the Fanuc control) alarm I am getting a code 16 and 17. I have tried googling a solution.

I know it's likely time for a new lathe however this machine makes one simple part, it's made this same part for the last 10 - 11 years and still makes good parts.



Thank you,

Tyler

[yours_linga]

WHats the status of drives ? Is there any alarm ? Please reply

[rockrunner86]

I didn't see any alarms on the drives, I will double check when I return to the shop. I believe they were 0 -- 0 on the three drives..

[rockrunner86]

Here is a photo of the drives they rear 00 -- and 00 which if I recall correctly is pretty normal.

[Dale123]

Its to do with Lubrication as below . Probably the pump .