Hey G'day folks,
Just a question regarding speed, I currently have my dm542 stepper driver resolution set to 1600 since replacing my old drivers. My cnc runs what I would say quite slowly.
eg pic Im posting.
I took a 3d model that I made with my resin printer and converted it to a bas relief.
I know how to control the speed of my print there are various things I can do to make it pint faster. eg decreasing the lift off time, increasing the resolution from .5 to 1 micron etc, the 3d print took 11 hours to do at the settings I had, I could have nearly halved that by doing other things but I wanted the best quality for a test I could achieve so 11 hours was good. Model hight 160 mm.
The carving took over 5 hours 320 x 190mm 1.5mm ball nose single pass no roughing done in cypress, (first time I've used cypress personally don't like it much).
My question, is my resolution to small? That carving I should be able to do in 2.5 hours half the time. I can increase the setting in uccnc to +200 the speed up does not work, I can go negative to say - 20 and my cnc will slow going about 100 has no positive effect.
I've been using uccnc for a number of years now I still really don't know too much about it.
I used Mach3 previously and going + over riding speed worked but not the same with uccnc.
Any information gratefully received, trying to save myself a little time for more real life stuff .. possibly lol.
Cheers,
Steve
Attachment 477342
Attachment 477344