I need some rods. Lots of rods.
7/16" dia 6061 T-6 aluminum, 5" long
Tapped M6 on both ends. 15mm thread depth
500 per month.
Please include material.
I need some rods. Lots of rods.
7/16" dia 6061 T-6 aluminum, 5" long
Tapped M6 on both ends. 15mm thread depth
500 per month.
Please include material.
You have a PM....
I've PM'd you with my quote.
Mark Reynaert, President Mark Mold and Engineering [email protected] http://markmold.com
You have a PM. Thanks.
Thanks to everyone who has submitted quotes so far.
I'm gonna leave this open until next Friday, then make a descision.
Hello, You have a pm
oh...material cost by the month not the whole thing....(in referance to pm)
Can I have a print or the tolerance on the overall length , diameters and dimension for the thread length , finish requirements.
please email me at [email protected]
my company website is miponline.com
I am located in Ontario, where is your location as shipping these parts could make a difference.
www.niagaratools.com
all dimensions are +/- .005"
raw stock finish is fine
parts will be shipped to Indianapolis, IN 46227
SENT YOU A PM ... YOU CAN REACH ME @ [email protected]
OR BY PHONE @ 254 - 576 - 2513
THANKS
Sent you a private message
I send you a PM with our quote
you have a PM
I was going to send a quote but your email is full.
You have a PM.
Has this job been awarded yet?