Hi guys, I'm starting another thread on the issue of ATC not working.
A bit of history, the parameters were deleted, i think from the machine being powerless for 3 years??
Anyhow I have put the parameters back in from an old floppy disk and from my service book.
The Mill is slowly coming back to life as i can now load programs but cannot change tools even in MDI. The changer basically turns back and forth, it doesn't actuate down and across. (Not an arm type tool changer)
zavateandu was greatly helping me out a few months ago but i think the issue was because the technician had my service book (4 or 5 months of calling him) which I had to go to and check some parameters and ladders. The ladders is something i have very little clue about other than i think its a series of switches??
Thanks guys
Bart