[machintek]

I have a list of parameters that are changed when installing a new spindle drive. i do not remember if i have a list of descriptions of these parameters. Next time in the office, I will check.

George

[inertialabs]

I appreciate your advise here, I just got back to Chip Sweeper about this as well. I don't want to simultaneously ask for the parameters from both of you but it sounds like you two are in contact with each other so I will thank you both and watch for an email.

Thanks again

Reason

[machintek]

Attached should be a note I received from Bridgeport in 1996 which lists the parameters Bridgeport was concerned with and what they are and do.
Use the list at your own peril.

George

[inertialabs]

Thanks for the parameters, I fired up the machine and I went into the parameter section and all of the parameters seemed to be very different than what was on the sheet, I am curious as to model machine you have ?

[Laundro]

Hi,

Sorry to resurrect an old thread! I just bought an old Bridgeport vmc 760 22. Unfortunately the Siemens spindle drive is missing its parameters. Just wondering if you could repost the parameters Machintek? The pdf no longer opens.

Many thanks,

J

Attached should be a note I received from Bridgeport in 1996 which lists the parameters Bridgeport was concerned with and what they are and do.
Use the list at your own peril.

George