[againstallodds1]

I blew up my rev 5 BOB....John sent a 5.2. Tried to install it today and there's no jack for the spindle enable plug to connect to. Anyone have any info on this? I've put in the emails, made the calls, left messages, googled the internet and cnczone......nothing yet.

Hey Mike,
I just recieved a 5.2 BOB from UPNORTH. I now have this same issue and wanted to see if you had any pics or can guide me in the right direction with getting the voltage needed for spindle enable plug.
I highly doubt ill be able to get one from Novakon, so maybe you can guide me in what needs to be done.
I have been running my spindle in manual mode since I have some serious issues with MACH controlling it. Its gotten even worst, then my last thread.

Thanks Paul