I have fanuc Robocut alpha OC wire EDM having fanuc Series 16-W control. I need to know
1. How to enable & disable parameter write.
2. Which parameters are for Axis backlash adjustment.
I have fanuc Robocut alpha OC wire EDM having fanuc Series 16-W control. I need to know
1. How to enable & disable parameter write.
2. Which parameters are for Axis backlash adjustment.
Press the SET key, it will bring up a menu screen. Use the arrow keys to navigate to to the right hand side of the screen, select “macro”. The press the select button for “soft op” (on the bottom on the screen). Use arrow keys to navigate down to PWE enabled, while hovering over PWE enabled type “1” then press insert. I believe a machine restart is required after.
For the compensation go to the AI screen type 9990 then press page up. Backlash compensation should be in one of those menus.
Good luck!
Does anuone knows if exist a PARAMETER MANUAL made for Fanuc for an Alpha 0-C with Fanuc 16-W controller?
I have an operator manual, but there is nothing about parameters.
Could you share it? I'll start looking for some of the parameters and I'll share it if I find it
Sure. Send me some e-mail address.
What is your email, sorry? Mine is [email protected]
It's sent.