I am lucky, yes.
But no, all of the offsets were correct.
Haas was stumped by this as well.
Nobody could figure out what was going on.
They kept saying 'well, obviously one of the offsets is different'
But they weren't.
So, I sent pics and video of the offsets, and the behavior...
I have no reason to lie here bud.
I was just looking to see if anyone else had encountered such an issue...
My dumb robot was NOT doing what it was told...
Here's the offset picture I sent to Haas.
There clearly was a glitch in the offset table, but not anywhere visible to us.
Everything was probed, and re probed.
Probes were calibrated and everything was probed again...
Running the tool @ G54 cut metal, changing nothing but the G54 to G56 in the program, and it cut air. (G55 cut correctly too, I tried it)
Close to 1" off.
54 and 56 were the same in the offset table.
Attachment 486082