[tld70]

Hello,
can you provide a Machine Number?
You tell tht eye button does not help.
If this is correct I think you have a faulty Eprom?
I can check the Eproms here.

Wait for your reply
Regards
Thomas

[mlinkadelsol]

The original message translated means "data parity error monitoring" giving the fault addresses. Could have been battery, but as you changed it, it's unlikely unless you lost the memory.

Do you have a parameter data backup you can upload?

Good day, battery is OK. I have the parameters but cant upload them because machine is stuck on the initializing screen and the "eyeball" button doesnt work. Also RED led on the back of CPU card is ON (if that means something).
Any help would be very appreciated.

[mlinkadelsol]

Hello,
can you provide a Machine Number?
You tell tht eye button does not help.
If this is correct I think you have a faulty Eprom?
I can check the Eproms here.

Wait for your reply
Regards
Thomas

Good day and thank you.
Machine number is : 471-09
Is it normal that the RED led is on on the CPU card?

[tld70]

Hello,
the red LED will be on ehen the CPU is not running,
If you press the Eye Button and switch on you will still have the alarm?
If yes, one of the Eprom Module is defect.
May this module you showed, the 2 eproms on the CPU Card or the module on the buttom
where the 3 small insertions are located.
.

[mlinkadelsol]

Hello,
the red LED will be on ehen the CPU is not running,
If you press the Eye Button and switch on you will still have the alarm?

I only see "initializing and testing" screen no alarms

If yes, one of the Eprom Module is defect.
May this module you showed, the 2 eproms on the CPU Card or the module on the buttom
where the 3 small insertions are located.

Do you have a photo?

Thank you.

[tld70]

Hello,
I do not have a photo,
You hav a defective Eprom module or the CPU card will be defective.
The problem is, I live in Germany
that means it is not easy to help you.

[lorberdejan]

Hello, Mr.Thomas,
i own a chiron fz12w ga2 1991- number 107-45, and the battery was weak and i lost all parameters,
i contacted the chiron and all they had was a files tea1 and tea2,
do you maybe own some files that can put the chiron back to life ?,
Best regards,
Dejan

[tld70]

Hello Dejan,
I have the S5D file if you have Step5 it is no problem to load this.
Give me your Email and I will send the files.
Best regards
Thomas

[lorberdejan]

Hello Mr. Thomas
My email is: [email protected]