It is rated for 24,000 rpm. I cannot achieve more 7,999 rpm any suggestions?
Any Help is appreciated
When running HZ registers 133.33 It is set to 400 hz 1.7 Amps
It is rated for 24,000 rpm. I cannot achieve more 7,999 rpm any suggestions?
Any Help is appreciated
When running HZ registers 133.33 It is set to 400 hz 1.7 Amps
Last edited by mpresti8; 02-21-2023 at 05:35 PM.
20 Amp circut
This unit was running at Max revolution until this happened
I have the GDZ-80-1.5B 24000 rpm 1.5 KW 110V 400Hz 5ASpindle water cooled
Run by the keypad on the front of the inverter no problems other than I wanted to slow it down because I believe it was running too fast for the surfacing blade i had on it. I was checking settings and the VI VR pin that you move the jumper on to change from the keypad operation to the Mach 3 software operation That is when i could not get it to work properly at this time it is shorted across the VR pins
Did you check if this Parameter PD144: Max Motor RPM is set to 3000
https://www.automationtechnologiesin...5-110vac-input
let me check that real fast
PD144 = 3000
PD144 = 3000
This Parameter PD144 is related to the Max RPM only.
This is the Parameters you need for KeyPad / Pot use.
Pot Control
PD001=0
PD002=1
PD070=1
JI Jumper 2-3=VI Position. You can try either position as some of these drives can be either for Pot use, these Parameters are important as well to make it run also for Pot control
Mactec54
Last edited by mpresti8; 02-23-2023 at 07:10 PM.
PD002=1 this needs to be 1 not 0
PD070=1 also for the Pot to work
PD007=20
PD025=0 Default
PD027=10 this is normally left at the default, if you want to use it than it should be set at the max of 10
You also may need these 2 Parameters set also
PD072=400
PD073=133 Your Minimum Speed
Mactec54
Mactec54
I am running from the VFD not the computer or Mach 3
Honestly this thing is driving me nuts.. One thing that I have seen on these YouTube videos is that when they change a value and press set the screen displays END mine does not display that
Give me a call, I will help you to check to find the problem
The phone number is on our website:
https://www.automationtechnologiesin...ucts-page/vfds