I am new to a control this old, and I can't seem to find any wear offsets. I am currently using common variables to adjust wear, and this can get rather complicated with more complex programs. Is there something I am missing?
I am new to a control this old, and I can't seem to find any wear offsets. I am currently using common variables to adjust wear, and this can get rather complicated with more complex programs. Is there something I am missing?
The specification of the OSP. Check if this control has the feature of tool wear management. This is not a default.
Look at OSP Software Management Data Card pages
"Imagination is more important than knowledge."
The U100 control only had geometry offsets and wear offsets were a very rare option. Most likely not on your control.
Experience is what you get just after you needed it.
hy aplowman like kurmay sugested, look for Software Management Data Card; can you do that, do you need help ?
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg
If wear offset functionality is crucial for your workflow, you should explore the possibility of upgrading the OSP U100L control to a newer version that might have dedicated wear offset features.