Originally Posted by reg.miller
Thanks for adressing to the question.
What is PM,PT ?
Does "const removal rate" option provide for a near constant tool tip cutting speed between straight lines and corners?
PM= Per Minute
PT= Per Tooth
And yes that is what const removal rate does. Now mind you this is probably about $15k or so just for the standard milling package. But you can do things like Trichodial milling and what not. It is very powerfull stuff.
Results 1 to 20 of 30
Threaded View
-
05-08-2023, 08:58 PM #24
Registered
- Join Date
- Jan 2013
- Posts
- 126
Re: controlling feedrate in tight corners.
Reply With QuoteSimilar Threads
-
Slow feedrate into/out of corners
By Eric Olson in forum FlashCut CNCReplies: 1Last Post: 06-24-2020, 08:37 PM -
Tool paths on letters help - getting the best edge inside tight corners
By Butcher84 in forum AlphacamReplies: 6Last Post: 04-27-2017, 08:04 PM -
Increased feedrate, getting rounded corners
By manyhats2007 in forum Mach Software (ArtSoft software)Replies: 1Last Post: 07-08-2014, 01:07 AM -
Feedrate override vs programming a faster feedrate?
By Zeppelin1007 in forum Mach Software (ArtSoft software)Replies: 2Last Post: 01-11-2013, 10:38 PM -
Milling Tight Inside Corners???
By Frogblender in forum BobCad-CamReplies: 11Last Post: 05-29-2009, 01:21 AM
Tags for this Thread
Posting Permissions
