Hello like minded folks:
I have designed and built a 1300 x 2600 CNC Plasma Cutter primarily for Aluminum cutting 2-4mm sheet. (I require full 1200 x 2400 sheets for my upcoming projects). A long build, but at the final steps.
I have hit a road block and cannot find the answers i am looking for regarding the software and hardware interface.
1. Software is UCCNC (current version)
2. Hardware is AXBB-E controller(needed ethernet connection)
3. THC Proma SD Torch Height Controller(only the SD version will work with the AXBB-E controller or so i am told)
I have got it all moving and hard limits set up however i am having some trouble with getting the relay wired in, and talking to UCCNC.
I've gone trough all the provided documents, searched YouTube and not having access to ask forum discussions, so the dive into YOUR knowledge would be most helpful.
My problem in a nut shell.
I have connected to UCCNC and am able to communicate with the rest of the CNC system( no problems there). I cannot control the torch "fire" relay trough the Isolated output ports(any of them). Isolated output Ports 1, O1-08.
I assume maybe incorrectly that i just have a checkbox left unchecked in a page somewhere. Yes i have THC enabled.
I have the Positive side of the relay coil connected to 24vDC and the negative in the attempt to connect to the Isolated 01 port/s assuming that the port closure would connect the negative to ground??
At this point i am only concerned with getting the relay to switch.
My question is:
If i do have the incorrect set up to control the 24v relay to trigger the firing of the plasma torch, if not then where should i have it connected?
What additional checkboxes do i need to provide UCCNC to enable control of the relay in the THC set up dialogue?.
I thank you all for any and all input.