[fabiancastro]

Hello, someone who has the error to reference the ATC and MAGAZINE in the MR-J2-CT data protect signal is input

[MrMetric]

Probably a battery replacement then reregister/home

[fabiancastro]

Probably a battery replacement then reregister/home

The batteries have been replaced with new ones, But the machine still has alarm 212 and 302

[MrMetric]

Bear in mind that I don't know this control. But it seems reasonable that you would need to re-home the system if the battery died and it was retaining positional information. That would mean that the control didn't really know the real position of the axis until you performed the re-homing sequence. To me, it seems like that is what you have not done... But, again, I don't know the Mazatrol system

[virendermohan]

MAZATROL 640M NEXUS


Mazak VMC the parameter cannot be written because the data protect signal is input .
(MR-J2-60CT DRIVE DATA RE-LOAD TIME )

[rphautomation]

In this case first is necessary to select the desire axis U(Setup axis), then open the test window to disconnect the drive from the M640 and then it is possible to edit parameters or reinitialize the absolute position, (While the test mode is on the protective signal is off)