[phomann]

Thanks for the very thorough answer. Helps a ton.

Do you know of any good posts for general reading on the SmoothStepper and g540?

Thx EZ

Hi,
For an example wiring diagram, have a look at this one I provide.

http://www.homanndesigns.com/pdfs/EN010_V8.pdf

As to the Estop, it should remove the mains power. That said some just feed it into a breakout board, feeding it into the controller software to invoke the Estop. This is not safe practice as if the software or breakout board is the reason you are pushing the Estop, it may not do anything

One caveat to that is if you’re machine can’t do any damage then it is probably ok. Say if you have a CNC machine that winds guitar pickup coils you should be ok.

The warp9 motion controllers and the G540 are a great combo.

Cheers


Sent from my iPhone using Tapatalk Pro