[sudsy]

Well i tried that but still no joy. I can't pick both sketches with a guideline and when i pick the sketch i have to do it one section at a time and then i get a error message saying to pick a continuous line. I'll try it in Fusion with a sweep and see if it works how i want.

[warrenb]

Well i tried that but still no joy. I can't pick both sketches with a guideline and when i pick the sketch i have to do it one section at a time and then i get a error message saying to pick a continuous line. I'll try it in Fusion with a sweep and see if it works how i want.

Try extruding each of your sketches to get a solid. Then loft solid face to solid face. Give that a try. But it is tough geometry to loft cleanly because of the curvature required