I recently bought my first table and I’ve been going through the struggles of setting up for the first time, the guy I purchased machine from had never setup or used the machine before so have been running off third hand knowledge so I’ve had to throw out any information I was given and start from scratch. I’ve been trying to get my machine to move with both Mach 2 and 3 on my 2 computers that came with the table it seems both versions(previously installed and supposedly Mach 2 had ran the table with original owner) will not communicate with the breakout board? So far I’ve only been able to manually function my z axis with one of the control boxes but no movement out of x/y axis other than when I first power up the table they will briefly engage and twitch for a split second. I guess my question would be what could I be doing wrong with the computer that is stopping it from communicating with the break out as everything seems to be active in Mach
Sent from my iPhone using Tapatalk