Originally Posted by
nitrodog
The D11 control is set up to retrieve nc programs from the host PC. Here is the protocols in the link-setup screen on the koike cnc.
I have the Link setups for my Koike Hybrid - D11
• DNC TIMEOUT (SEC) 3.0
• ASCII REWIND 8
• ASCII DIALOG START 33
• ASCII DIALOG DONE 42
• ASCII DIALOG PROMPT 3
• ASCII DIALOG ACKNOWLEDGE 62
• TRANSMIT DELAY 10
• SCAN FOR ctrl-Z DOWNLOAD OFF
• SEND EOT UPON DOWNLOAD FAIL OFF
• DOWNLOAD MEM CAPACITY AS % 30
• AUTORELOAD POINT AS % 25
• RS-232C BAUD RATE 9600
• CHARACTER CODE ASCII
• PARITY IGNORE
I have tried easyDNC, DNC Precision, and NCnet lite4.1. No luck as of yet.