[davida1234]

Screw down both ends of the drag chain.

Attachment 505924

Attachment 505926

[davida1234]

Install gantry beam end caps on both sides.

Attachment 505928

[davida1234]

Y/A axis drag chain installed.

Attachment 505930

[davida1234]

It seems that somehow my last images did not upload properly.
Here there are again,

Install bolt.

[davida1234]

Snap on mounting plate onto bolt.
Make sure it can rotate freely on the bolt.

[davida1234]

Screw down both ends of the drag chain.

Attachment 505936

[davida1234]

Install gantry beam end caps on both sides.

[davida1234]

Y/A axis drag chain installed.

[davida1234]

Slide in X axis shelf bracket.

Attachment 505952

[davida1234]

Push up against the end cap.
Slide in the two angles into slots.

Attachment 505954

[davida1234]

Do the same on the other side.
X axis drag chain shelf installed.

[davida1234]

Install bolt onto X carriage.

[davida1234]

Snap on mounting plate onto bolt.
Make sure it can rotate freely on the bolt.

[davida1234]

Screw down both ends of the drag chain.

All drag chains installed.

[davida1234]

.


This concludes the mechanical portion of the machine.

Next up will be plumbing/electrical and the expansion sets for the machine.

[peteeng]

Hi David - Great intermission, I can go and get some Jaffas.. Peter

[davida1234]

Hi Peter, I actually had to look up Jaffa. I hope you enjoyed them.

[davida1234]

.


The prices for the complete machine shown up to this point will be:

2 x 2 size: $2,975 (plus shipping/handling).

2 x 3 size: $3,300 (plus shipping/handling).

2 x 4 size: $3,800 (plus shipping/handling).



Included in these prices are:

All aluminum and plastic pieces (as shown in this thread up to this point).

All aluminum profiles (as shown in this thread up to this point except the gantry beam).

All rotating ball nut drives with belts and motor pulleys (as shown in this thread up to this point).

All linear rails and trucks (as shown in this thread up to this point).

All necessary hardware (as shown in this thread up to this point).

Transparent splash screens (as shown in this thread up to this point).

Drag chains (as shown in this thread up to this point).

3 sensors.

Pre-assembled basin pan with T-slot table.

Pre-assembled X/Z carriage.



Not included in this price are:

Gantry beam. (There are different manufacturers at different price points)

Motors

.

[davida1234]

.

Following accessories in this thread are all optional enhancements and are not necessary for operation of the machine.

[davida1234]

.

Junction box.

Install mounting plate to X carriage.