Screw down both ends of the drag chain.
Attachment 505924
Attachment 505926
Screw down both ends of the drag chain.
Attachment 505924
Attachment 505926
Install gantry beam end caps on both sides.
Attachment 505928
Y/A axis drag chain installed.
Attachment 505930
Screw down both ends of the drag chain.
Attachment 505936
Slide in X axis shelf bracket.
Attachment 505952
Push up against the end cap.
Slide in the two angles into slots.
Attachment 505954
Hi David - Great intermission, I can go and get some Jaffas.. Peter
Hi Peter, I actually had to look up Jaffa. I hope you enjoyed them.
.
The prices for the complete machine shown up to this point will be:
2 x 2 size: $2,975 (plus shipping/handling).
2 x 3 size: $3,300 (plus shipping/handling).
2 x 4 size: $3,800 (plus shipping/handling).
Included in these prices are:
All aluminum and plastic pieces (as shown in this thread up to this point).
All aluminum profiles (as shown in this thread up to this point except the gantry beam).
All rotating ball nut drives with belts and motor pulleys (as shown in this thread up to this point).
All linear rails and trucks (as shown in this thread up to this point).
All necessary hardware (as shown in this thread up to this point).
Transparent splash screens (as shown in this thread up to this point).
Drag chains (as shown in this thread up to this point).
3 sensors.
Pre-assembled basin pan with T-slot table.
Pre-assembled X/Z carriage.
Not included in this price are:
Gantry beam. (There are different manufacturers at different price points)
Motors
.
.
Following accessories in this thread are all optional enhancements and are not necessary for operation of the machine.