[mpzone]

Hi all,

Yes I know it's an old board, but still OK. I am currently retrofitting a Wabeco mill with it and am trying to integrate the spindle control.

I thought that the board was able to output a PWM signal and bought a PWM to 0-10V converter. I assigned output pin 6 to the converter (speed in SW) but not getting the 0-10v signal. Anybody knows what kind of signal is used for speed control?

Thanks in advance!

Kind regards Maarten

[PlanetCNC]

Mk2 controller does not support PWM.

[mpzone]

Mk2 controller does not support PWM.

Ok, thanks. But what output signals are available? Are there options to get 0-10v without having an output board?

[PlanetCNC]

Controller outputs frequency output, user needs a device that converts such signal to 0-10V, on such device is offered in our webshop.
Or you can order third party product, or make one yourself.

[mpzone]

Controller outputs frequency output, user needs a device that converts such signal to 0-10V, on such device is offered in our webshop.
Or you can order third party product, or make one yourself.

Ok thanks you for the answer. I went for the safe solution and sourced a mk2 output board @ sorotec.de. that should work!