I'm selling the parts I no longer use on my 1995 Milltronics Partner 1 series H. I have gone with a dynomotion/kogna retrofit. I'm open to offers.

Custom servo motors NB1902FRM-445 12.5? HP spindle servo motor , MPA-50-mill spindle servo drive, and electronic gear shift (wye-delta contactor board). I would like to sell these as a set if possible for $4000. I reverse engineered the electronic gear shift and 12 lead motor windings in the hopes of using this setup, so I could provide electrical schematics, and a copy of the servo drive manual. Disclosure: I had to replace a mosfet once and an internal fuse on the servo drive several times when I ran it on a RPC. It is in working order, but I do NOT recommend trying to use it on a phase converter.

Centurion V control, it's the type with a compactflash card $300.

Front panel with LCD screen, without MPG $150.

A ton of other misc Milltronics parts, relay boards, DC power supplies, etc. If you're looking for a part I didn't bother to list, let me know.

Located in southern Oregon.