[adriancampion]

Hello all
Im trying to set the distance parameter a axis will move but when i add decimal point to number it doesn't enter goes to single number.
So has anyone experience in setting these up ?
https://youtube.com/shorts/NSwxFMO2NxI?feature=share
look here for vid

[adriancampion]

https://youtube.com/shorts/NSwxFMO2NxI?feature=share
look here for vid

[mcode]

It has to be a number between 1 to 999999999, no decimals because it's a motor pulse count.

[adriancampion]

also same issue with next line axis rotation

[SparqLee]

also same issue with next line axis rotation

Write full lengts of numbers: examle if microsteping is 6400 and reduction ratio 3 you have 19200 steps per revoliution after reduction, Calculate full travel length per revoliution you mecanical part, if 1,5 mod have 4.71 mm pitch betwen tooths, with 15 toth, per revo you have 70,65mm convert to 70650 microns
example
p0188 19200
p0189 70650
for ball screw if mod is 5 mm per revo
and microsteping 1600
example
p0188 1600
p0189 5000