[Jarwalcot]

At Doosan, we have a wide variety of Installation Manuals, Service Manuals, Alarm Manuals, and Technical Documents that simplify the troubleshooting, diagnosing, and repair of our machines.

These manuals are available to the general public.

There are way too many to post them all here... (though, if enough people request a specific manual, I can post some of the smaller ones...larger ones will exceed this site's limitations)

The attached screen capture shows a minuscule sampling of the available documentation.

Mr. Dhardt,

We have an older (2003) Deawoo Puma 300 with a Dead Center Tailstock. The quil locked up and we’ve ordered new bearings. You wouldn’t happen to have a tech bulletin/procedure on how to replace them would you?

I’m looking through your shared google drive without any luck. Thx for sharing though!

JR

[anr.red]

Need help following the electrical diagrams in the one I have for a Daewoo 10 HC. Darryl gave me a brief description a long time ago,lost my notes,now can't follow it.Just got an alarm 05,machine control trip,found the breaker,can't follow wiring in book. Machine has an fanuc ot control.Any help would be appreciated,Thanks

[dhardt]

The Lynx 220LMA could be built two different ways over the years.
Serial numbers that begin with ML are likely to have a front mounted live drive and use the turret type shown in this manual: https://drive.google.com/file/d/197e...usp=drive_link
Serial numbers (old style) that do not begin with ML are usually rear mounted live tool type: https://drive.google.com/file/d/1vlb...usp=drive_link

Helpful additional info:
Crashed turret confirm and repair training video: https://youtu.be/7Ucg2v3jEgs?si=OpDWA2f-TPKTg8D3

[PartsMachineStation]

Mynx 6500 Electrical diagram?