Hi there,

I was running a job today with nested parts that need to be stacked together. Its a DIY machine i've not used for a while and I noticed some corner rounding on inside pockets. In fact different radii depending on which corner it was of the box.

I consulted a couple of threads here and realised that Stop CV on angles was not turned on. I can see its recommended to turn it on and set the degrees to 89. I did that, saved, restarted and redid the job. It did improve the issue but not cure.

I took a note of my motor settings and wonder if I should be looking to increase velocity, or another value. if so by how much?
Vel: 8502
Acc: 600

These are a few setting I noted down before coming home today incase these were of use.

Lookahead 200 lines
Distance Mode: Incremental
IJ mode: Incremental
CV Dist tolerance: off
Debounce interval: 1500
Kernal speed 45000Hz

Any help most welcome