[peteeng]

Hi All - Does anyone have a UCCNC Laser set up 101? Reading thru the info now. I have a 5W 12V diode laser to connect to my router using the UCCNC laser plug in.... Peter

may be this will help - peter

https://jtechphotonics.com/?page_id=3905

[arturod]

Check this out:
https://www.cnc4pc.com/blog/post/wir...with-c76-board
https://www.cnc4pc.com/blog/post/ucc...-module-on-c76

Arturo Duncan
https://cnc4pc.com

[peteeng]

Hi All - Laser is now working fine. Prefer a vector approach vs the raster but it works. Peter

[LorenBMS]

Hi Pete,

I know this is a little dated, but I have just added an Opt Laser to by UCCNC controlled router. It has me scratching my head on some of the Gcode controls coming out of Lightburn. I was wondering if you had any experience with this on yours?

Thanks,

Loren

[peteeng]

Hi Loren - Only ever run the laser macro from inside UCCNC. Haven't tried running external code. I suspect it may be a little difficult as the code for the laser has to be processed much faster than usual cnc Gcode. Sorry can't help much on this one. I do use lightburn on another laser machine and its always been straight forward on that machine. Peter

[LorenBMS]

Thanks Pete...I will keep trying to figure out the secret sauce.