Hello all. I am trying to do an inlay using Aspire. For my female pocket, I am using 0.0 for start depth and .11 for flat depth. For my plug, I am using 0.09 as my start depth and .02 as my flat depth. I used a 60d VBit for both pieces. When finished, the plug blank bottoms out on the surface of my male piece and there is a lot of play with the plug, certainly not tight. The plug also bottoms out in the bottom of the female pocket. What am I doing wrong here. I have attached screen shots of my settings as well as a picture of my test pieces using the same setting as mentioned above. Any help would be greatly appreciated.