I'm looking at a similar type of project, my taper is on the O.D. and it's about 52" in dia. I was wondering if chucking up a carbide bur in my mill would work for the basic roughing?? I have access to a 8" long set of bur's which would reach just dandy [max needed depth is ~6" or so] but I'm not sure if this would work...Crazy idea?
Curious..
Jerry
JerryFlyGuy
The more I know... the more I realize I don't
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)