[walter]

Zone adds embedded video capability.

[boguski.1]

wow. very cool!

[walter]

Edited:

300W AC servo motor tested with sinusoidal AC drive (controller designed by CNCzone member Xerxes)

[Geof]

Tentatively phrased so I don't get accused of being picky but didn't Xerxes design the servo controller not the motor?

[walter]

Ultimate Factories: Ferrari!
(robots show up 25min into the movie)

[Switcher]

DATRON High speed milling machines

[Switcher]

This is cool!

STAMA System 7 HIP SOCKET CUTTING DEMO

[walter]

Awesome.

[tsutt]

Neat, Looks to me that there is a couple people out of a job in the first video! Todd

[walter]

There's nothing CNC about this video..
But it is very inspiring and will give you a boost if you happen to need that little extra push.

[Geof]

A question from a computer and internet luddite. How do you upload a video and to where in order for it to be embedded?

[Switcher]

All the videos in this thread are hosted outside of the zone, (youtube, google video).

[Geof]

All the videos in this thread are hosted outside of the zone, (youtube, google video).

Thanks, I had a look and both want you to sign on so I will think about it.

[walter]

Geof, visit the original page for this video: http://www.youtube.com/watch?v=SeUMDY01uUA

Look at the frame on the right side, where it says Tags, URL, Embed

Copy the text from Embed window and paste it in the Zone message body.

That's it. No need to sign in or register.

[Geof]

Thanks Walter. I was wanting to be egotistical and upload some of my own CNC videos but to do that I gather I would have to sign in. I am going to see about setting up my own website and I guess I can embed them from there. Once I figure out how to do everything .

[Switcher]

Did you know you can change the size of the video when you post it here on the zone?

1) width="425" height="350"

2) width="825" height="750"

The only thing is, If you make it to big the quality gets bad.


.

[walter]

Thanks, I had no idea..

Geof,
Good thinking. I was hoping people would start showing their stuff!

[Glidergider]

I built this DIY JGRO router starting about 3 months ago. My other hobby is RC Sailplanes, but this CNC stuff has consumed my attention and sailplanes are gathering dust. Very addicting. In the video, I'm cutting a laminated foam wing, to reduce its weight.

[MrBean]

I just finished milling a PCB. Not very exciting, and YouTube made it go all blurry.

[walter]

Very cool. Thanks for posting!