After reading the post in this section, it just read like someone wanted some help with the software and the others were saying there was nothing wrong with the software.
Thread: asking for a post?
Results 1 to 20 of 28
Hybrid View
-
05-24-2007, 12:03 PM #1
Registered
- Join Date
- Jul 2003
- Posts
- 86
FORD = First On Race DAy
-
05-24-2007, 05:02 PM #2
Registered
- Join Date
- Apr 2003
- Posts
- 1876
You're close.
Originally Posted by fjd
Someone used (very) bad judgment in running a NEW POST PROCESSOR on their machine without testing it first, crashed it, and is now trying to blame Mastercam for it.
I mean, if an individual is foolish enough to run BRAND NEW CODE on their machine without even looking at it first, that's not a design problem, that's an operator problem.then you get your mastercam and put in the post for your machine and procede to put shiny new tool marks on your new cast iron table.
"Close your eyes and push the big green button."Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
05-24-2007, 08:32 PM #3
Registered
- Join Date
- Jul 2003
- Posts
- 86
kool now iam getting a better picture of it
i don't even do that with old posts and old programsFORD = First On Race DAy
Reply With Quote
Posting Permissions
