Hi AjaxCNC
How much user configurability is there to your systems? It is great to have good clear instructions on how to hook up and get it all running, but what if my ideas for the interface don't match yours? What freedom does the user have?
How does the DOS system compare to the Linux? I'd hate to go back to 8 letter DOS, so does the Linux system run "inside of a Linux window" (by analogy), so that a person at least has a multi-tasking environment to work in to edit, copy and paste, load programs, run a cadcam program etc?
What about using a Galil motion control card with your systems? Is there any compatability?
Thanks for your time to reply.
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)