I have a bridgeport series 1 eztrak mill and I am getting the parser error for my z axis. I am new to machining and inherited this machine in a company takeover so I do not know if a repair is needed or what. Any help is appreciated.
I have a bridgeport series 1 eztrak mill and I am getting the parser error for my z axis. I am new to machining and inherited this machine in a company takeover so I do not know if a repair is needed or what. Any help is appreciated.
It means that based upon where zero is set on the Z axis, you are asking it to move further than it can.
You must have a 3 axis TRAK. You probably have not set the TLO(tool length offset) or a tool and are commanding it to go .050 above zero which it cannot do since it is all the way up and at zero already.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)