I need T1 parameters for a QT10 lathe...bad
I need T1 parameters for a QT10 lathe...bad
Chucker Or Universal? Square Turret or Drum Turret?
12 pos turret (drum) Universal
I have parameters in VGA quality, from my HP.
Hope this help.
Greeting
Tarom
I have thos eparameters and if you can post the other parameters for chuck data ect in the other menus that woudl help out a TON!!!
ok, let me know, what's the problem now?
because T1 only need these parameters, cutting conditions, set tool barrier, chuck barrier, stroke limit.
QT10 and QT20 almost same.
Let me go through these today and I will get back to you. I thought this was just the 4 pages of parameters not the chuck data...It appears that you didnt post a pic of the travel and chuck data but I havent been to the screen in a while. I will post up in a couple hours! Thanks for staying with me!
If you could post your chuck barrier data like I have listed below...these are the parameters I am missing. I have a worksheet for the others but not for these. You press the Set-cond button to access these I believe. I dont know if a qt20 would have the same parameters in this area
i attached cutting conditions, and tool set (chuck barrier,tail barrier, stroke limit) in japanese language display.
these parameters from QT1 ST30, but almost same with QT10,QT20.
BTW, don't forget to set zero all tool number (XZ)
Sorry i mean T1 ST30
i lost my perameters both pages on my mazak qt 10 universal with a mazatrol t-1 any one have any pics so i can restore them. thank you in advance