Well after many months of getting the right parts, the right electronics, asking alot of questions, SHE IS ALIVE.
X-2 stripped of everything not relevant. KDN Tools conversion (they are an incredible company, HIGHLY Recommended), Gecko 203V, PMDX Boards, Half enclosure, Mach 3, Roller Home switches.
The Enclosure is made from Scrap Corion Countertop Material, so easy to clean the chips off.
Right now I'm a button pusher, still have some setup issues to resolve before I can let her run under G-Code.
Here are some photos.
Not sure if the homeing is working right:
Z Head moves up,DRO reads positive
X Table moves to the right, DRO reads Positive
Y Table moves toward column, DRO reads Positive
Not sure if those are correct, any comments welcomed.
Smitty