Hi i have been running a record on for the past 10 years. I have parts. num 720 manuals postprosesor for alphcam and a lot of experience.
regards p_ken
Hi i have been running a record on for the past 10 years. I have parts. num 720 manuals postprosesor for alphcam and a lot of experience.
regards p_ken
Hi p_ken,
Nice to hear from another record owner, can you help with this problem I have.
I have been running the scm record 1 for around 6 months but have been unable to get the drip feed working. Following the instructions from the NUM 720 manual does not work.
So I can only run very small programs + - 1200 lines of code
Hi fictionist,
Let me have your e-mail details and I will send Num 720 manuals to you.
File size for 720 is about 14meg.
I also have Num 820 if needed.
Do you use drip feed on your machine?
Regards [email protected]
Thanks a lot for the quick response. My email address is [email protected]
Regards form the sunny Cape Town
Hi p_ken,
i am a member of CNCzone.
we recently bought a used CNC machine and are missing the manual.
Would you mind to send me a manual ?
my email adress is [email protected]
Thank you very much!
Hello everybody,
I also need a copy of num720 manuals in english.
My e-mail is [email protected]
Greetings from Greece
Thanks a lot
Hi All,
Does any of you lot use Xilog or Xilog plus.
If you need any help just give me a shout regarding Xilog or Xilog plus.
Also I have an alphacam post processor for the NUM 720, NUM 750, also for the RECORD 220 I have two post procesors.
You might need to tweek them.
Shaun
Hi Chris,
I don't use drip feed.
The programs i use are stored on a server called (k drive).
I don't store any programs on the control.
When the programs are opened up in panel mac and run they are actually all still on the server and the programs run fine.
To do this all you need to do is put your control on the network and access is dead simple
If you need more info let me know and I'l do a demo.
Shaun.
Hi Shaun,
I am working on a Record 220 & would certainly like an Alphacam post if you still have one.
Thanks
Alan
Hi Shaun/All
I appreciate this tread is rather old but I've just bought a SCM Record 1 and require an Alphacam post processor for the NUM 720, is that something you can still help with!?
Thanks
M
Hi all
Also just recently purchased a SCM Record 1 num 720 and be grateful for any manuals, posts or advice with this machine.
Also we can not work out were the c1m1 wire at the back goes, so any wiring diagram be most helpful....
Thanks for any help.....
[email protected]
Hello,
My company produces a text editor with DNC for CNC controls. I have been asked for help in connecting an SCM Record1 with NUM 720 controller to a PC.
I cannot find any communication parameters, and there is no manual available.
Can anyone help?
Harry
Hi Harry,
Sorry for replying to you through this post but it was the only way I could send an attachment.
Thanks for your interest.
Look forward to hearing from you.
Kind Regards
Chris.
P.S. The file is a job sent from the machine to the PC.
Cheers
Hello evey bady
We recently bought a used scm record 220 (1999) as a second machine for 5-axis jobs and are also missing the manual. Would you mind to send me a manual as well and electica wiring to install
My e-mail is [email protected]
Thanks a lot in advance