[sqatch]

Hi Wes thanks for the help. The -0.5 is my sloppy editing not the post. and I found a ij absolute word command for my controler which is supposed to override the relative IJ G02 and G03 commands.I'll try this tomorow. I tried to find a setting then tried the manual not a man thing to do but I was desperate.

[metalworkz]

I hope you are able to get it running correctly. I had a similar problem with my controller and the Dolphin posts and it was interesting how a simple tick mark in the wrong place would end up looking like garbage on the display. Good luck tomorrow!
Regards,

[sqatch]

Well that had no effect so I went over the cad file and cleaned it up there was a mess of points left over from past edits and loops at the tips of the flames were I was having the problems.Sloppy + lazy = more work

[metalworkz]

I'm glad you figured it out. I do most of my drawing and cleaning up in Autocad and I notice when I re-import back to Dolphin I sometimes have to do a little more cleaning up. Often some of the same things I just finished fixing somehow get jacked again when they are imported, so I usually look things over good when imported to make sure it's still good. Good to hear you got to the bottom of it.