You have to find a lathe just like yours or get a hold of a dealer that sells or sold tornado lathes. The diag parameters control all the switches that run the lathe. If you can save to a pc that would tell you if they are there. Put the control in edit, push the diag/parameter button, might have to push it twice, it should say diagnostic in the upper right hand corner of the screen, then push output and it will send them to the pc. Look at the file, the number you will see are 10300-10549. If they come up with all zero's then they are missing.
I just went through this on my Takisawa with a Fanuc 0T, I was able to get them from the Takisawa dealer, thay had them on file thank goodness.
Good luck,
Dave