[dertsap]

the latest of my lunacy
it still needs some more clear coat ,its only got one coat to seal it right now , a couple more coats and a little stain will bring out better detail

[dan dimock]

What is the size of that piece? Also did you produce the file for it are is it posted in the forum?, as I would like a try at marking one.

Dan

[dertsap]

What is the size of that piece? Also did you produce the file for it are is it posted in the forum?, as I would like a try at marking one.

Dan

the engraving is 10 x 10 x .2 dp
ive attached the gcode file , pickup your w/s start point as x-.5 y-.5 , this is because the software i used creates a .5 boarder around the engraving ,
grab a case of beer , kick back and relax because this one takes a while

the bit i used has a draft angle of 15deg , so you may want to use a sharp angled bit in order not to loose any detail , a slight rad at the tip of the tool will create a smoother finish as well because the step over is .03