I have hit a bit of a road block trying to figure out my coil wires. Am I right??
I have a six wire Kelling Motor (KL23H276-30-6A) 3 Amp/Phase 2.0N.m. I am using uni-polar drivers.
I think my wire config should be this:
Center Tap Coil #A = White
Wire #1 = Red
Wire #2 = Blue
Center Tap Coil #B = Yellow
Wire #4 = Black
Wire #5 = Green
Using my ohm meter I determined the following:
Wire colors = Red, white, green, yellow, blue, black.
Red on Common
Blue - 2.5 ohm
White - 1.7 ohm
White on Common
Red - 1.7 ohm
Blue - 1.7 ohm
Green on common
Black - 2.5 ohm
Yellow - 1.7 ohm
Blue on Common
Red - 2.5 ohm
white - 1.7 ohm
Yellow on Common
Black - 1.7 ohm
green - 1.7 ohm
Black on Common
Yellow - 1.7 ohm
Green - 2.5 ohm