I have an imported IGES file of a part that needs a few features added and machined. I set up a new WCS for the part and called it OP-1. I made OP-1 my current WCS and made sure both T plane and C plane were checked for the OP-1 WCS. I then saved this file as an .STL file so I could use it as the start point when doing verification on the features I added to this existing part.
In Verify I choose the .STL file I saved but the coordinate systems is in the wrong place and Verify cuts the feature on the wrong side of the part and in the wrong place.
Can someone tell me what I'm doing wrong? How about a step by step on how to use an .STL file for Verify?