I would like quotes on the attached file and turn around time. Please email them to hobbymachine at mchsi dot com Thanks!!
I would like quotes on the attached file and turn around time. Please email them to hobbymachine at mchsi dot com Thanks!!
what kind of tolerances are required any critical areas?
Has this job been awarded? Thank you.
Philip Confalone
Machining Concepts
Thank you for all the quotes. I will going over them.
For your reference:
This is a simple part with +/- .005 tolerence that I machine in under 10 minutes in 2 setups.
First side is the 4 holes and counterbore, second side I cut the outside and step on a fixture.
I pay less than a $1 for material.
A few of the quotes I received were close to $20/piece. If I could charge the customer that I would do them.
Anyway, thank you.
I guess the answer to my question would be no? Thanks.
Philip Confalone
Machining Concepts
Robert, did you not get my email? My quote is quite a bit less than $20/ea.
Hmm...
I also was way under $20/pc.
-Sean
my quote was well under $20 as well
Yes I received all the quotes and thank you all for your time. This job has been awarded.
Can you post what the winning bid was and the time time frame of the delivery?
I won't post the winning bid but will say it was way under $10. About a 1 1/2 weeks to get.