Hi There Adobe,

Thanks for the words of hope. Yes, I also bought 3 Gen-II controllers, all directly from IM Services. I'll prepare a reply, outlining all the problems I've been faced with. All I want to be able to do, is route out plywood parts, for my model aircraft.

Just to check, my installed software is v2.0.1.108, is that the "latest and greatest"? What is the latest operating manual available, with instructions on how to route out parts? The trouble already starts here for me, as the selections are Pocket, Contour or Drill. My CAM glossary is not up to speed yet. I figured out it should be Pocketing.

Any way I could be able to use the DeskCNC card, with other CAM software, ie get another post processor to run it from say Flashcut software?

Regards,

Francois