i am getting alarm 6 in both of the yaskawa CACR HR10SB sevopack drives for pallet changer & magazine rotation (machine is kitamura my centre H-400).Can any body help me?
i am getting alarm 6 in both of the yaskawa CACR HR10SB sevopack drives for pallet changer & magazine rotation (machine is kitamura my centre H-400).Can any body help me?
You can download the manuals for the drives from the yaskawa site.
Hi gidley51,
I have downloaded the manuals & also checked according to that but every thing seems to fine. But alarm still there i.e larm no 6 under voltage
According to the manual,error six is undervoltage as you say.Yaskawa`s explanation is to switch the power on and off and if the error is still there to replace the Servopack drive.It seems strange that both would fail at once without outside interference.Are you sure the input voltages are correct?
Hi gridley51,
yes it seems strange to me also but it happened to me. Input voltage is o.k . today i am planning to dissemble the drives & check for some damaged parts may be thryster or some diode.If you have some more information for this alarm , Pl share with me.
Have you sent an E-mail to [email protected]? I found they are pretty good at answering E-mails.
"Plan your work; Work your plan"
Sorry all I know is what`s written in the manual.I have never used Yaskawa drives although I have fourteen of them in the stores which I recently acquired along with matching motors.
I too recommend you email Yaskawa.
Mark.
You can download SigmaWin+ software from Yaskawa, Thats what I did. I had the same thing happen= A.40 alarm in the software= overvoltage.
I think mine is blown maybe yours too, some kind of power spike maybe. Anyway, the software connects to the drive and gives all kind of information,much more than I can understand right now but in a format that is understandable. AND, you can clear the alarm and reset it. You have to make a cable to connect, I made one out of an old RS232, the help file in the software shows the wiring diagram. Good luck.
hi j69usa,
thanks for suggestion, but i have sent drive for repairs. once they come back, i will revert back to you . anyway thnx very much.
Hi there is chance fuse in the servo may be blown off.So pls check or there is also a chance of control card failure.If you require any upgrade support for yaskawa products in india you can contact me at Mob:+91-9967360681 Email:[email protected]
Pls check the internal DC bus and there is chance of problem with contro card.If you require any technical assistance for yaskawa servo and Motion control products in inda You can contact me on Phone:+91-9967360681/Email:[email protected]
Yaskawa servo technical support in india contact:ArunNS Hand Phone:+91-9967360681
Who know about Servopack CACR-SV02ER?
Contact: Arun N.S for Yaskawa Servo Support in India.
Email:[email protected]
Mobile:+91-9967360681/+91-9930044314
Yaskawa servo in India
Call for Yaskawa servo Techinical support in India
Arun N.S
Mob:+91-9967360681
[email protected]
Arunns: Technical support for YASKAWA SERVO and MOTION controllers in India.
Mobile:+91-9930044314
Email: [email protected]
Email:[email protected]