good evening,
I have a problem with the x-axis when you move in fast moving x only moves with a preview of 495mm/min that only happens in a positive sense
in advance thank you very much
jorge
good evening,
I have a problem with the x-axis when you move in fast moving x only moves with a preview of 495mm/min that only happens in a positive sense
in advance thank you very much
jorge
What is your Fanuc model ?
Your machine is new machine or used machine?
FANUC 18MC
CENTER MACHINING HORIZONTAL
KIA H50
MODELO 2000
4 EJES
2 PALLETS
PARAMETERS WILL BE OR ELECTRONIC
Jorge,
Check if the signal X6.5 stay in 1. If yes, the limit switch of reference is active. You need fix that.
Daniel
friend thank you for your response,
BUT THE TRUTH not know WHERE CAN I SEE THE SIGNAL x6.5
Thank you in advance
JORGE
Try SYSTEM, PMC, PMCLAD, type in X6.5, press Search. Don't know if you need the .5. I am only a lowly lathe programmer.
Jorge,
Like G-codeguy said, this is on way. But there is more one. PRESS SYSTEM > PMC > PMCDGN > STATUS. Type X6.5 and press NO. SRH. And remenber. Hyundai-Kia machines has the ladder open. It´s possible you edit that.
Good Luck,
Daniel
Good morning,
Friend apology but the truth do not know if I understood.
is that I am Colombian and I do not speak or write English, but the problem is that the X-axis moves slowly in a positive sense and in the negative moves fast
because if the solution to that problem is no excuse but to understand
as publishers that parameter in the machine?
jorge
I found this following the path you told me.
X0006 5
exdexl
0
ME THAT INDICATES THAT?
Jorge,
The limit switch of reference of the X axis are broken. Check that. The signal must stay in 1 when the axis is out of reference position.
Daniel