Go to http://www.nookind.com/ball/BallCatalog.cfm and look in the technical sections of their catalogs. They should have charts showing critical speeds and load capacities for all their different size screws. Lots of good info in all their other catalogs as well.
Thread: Ballscrew size -vs- project size
Results 1 to 5 of 5
Hybrid View
-
10-19-2004, 01:14 AM #1
Community Moderator
- Join Date
- Mar 2003
- Posts
- 35538
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
10-19-2004, 02:53 AM #2
Chip Sweeper
- Join Date
- Aug 2003
- Posts
- 79
Thanks,
That was a great source of information. Unfortunately I have a headache from reading it. :drowning:
Just kidding. Thanks for the link.(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With QuoteSimilar Threads
-
Ballscrew Basics
By Swede in forum Linear and Rotary MotionReplies: 137Last Post: 04-05-2024, 08:10 AM -
NanoMill project
By chuckknigh in forum DIY CNC Router Table MachinesReplies: 9Last Post: 03-18-2005, 09:14 PM -
Ground Ballscrew - No nut!
By Swede in forum Uncategorised MetalWorking MachinesReplies: 4Last Post: 11-20-2004, 09:42 PM -
ballscrew size ok?
By jntambs in forum DIY CNC Router Table MachinesReplies: 13Last Post: 03-07-2004, 12:27 AM -
ballscrew repair and some general questions
By jimbo in forum DIY CNC Router Table MachinesReplies: 11Last Post: 09-27-2003, 09:48 PM
Posting Permissions
