![Quote](images/misc/quote_icon.png)
Originally Posted by
HackerMechTech
Okay did my first full up test. It runs pretty damn SMOOOOOTHHH! I ran the three phase shaper I picked up a few months back. Beautiful! No hichup on startup, just nice smooth motion on the machine and the idler.
L1 = 240V
L2 = 240V
L3 = 235V Generated.
I'm happy. ....
..... Now that grounding system......
Andrew
When I ran the 100 amp service from the main house to the workshop subpanel, it was required that I put in a seperate grounding rod and "Not" use the bonding screw inside the new subpanel. I would double check with an electrician to be extra sure.
Mike
Warning: DIY CNC may cause extreme hair loss due to you pulling your hair out.