Well, 40 ft/lbs is way too much (don't ask...)
I just do what the factory says, I use a 1/2" ratchet to drive the socket and choke up on the handle, then tighten. I'd say 20-25 ft lbs is probably about right.
Well, 40 ft/lbs is way too much (don't ask...)
I just do what the factory says, I use a 1/2" ratchet to drive the socket and choke up on the handle, then tighten. I'd say 20-25 ft lbs is probably about right.
Nick Carter
Largest resource on the web about Taig lathes and mills
www.cartertools.com