So I bought a new machine because my laptop was just not powerfull enough.. All set up, ready to go. Loaded mach.. and fired it all up and get nothing.
It says VB System failure at the bottom field...
Anyone?
So I bought a new machine because my laptop was just not powerfull enough.. All set up, ready to go. Loaded mach.. and fired it all up and get nothing.
It says VB System failure at the bottom field...
Anyone?
Did you reboot after installing, but before starting it the first time? If not, try uninstalling, then reboot, then re-install, then reboot again before starting Mach3.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)