To my knowledge you cannot remove the final profile but by changin your D value you can make it the same depth of cut as all the other passes.
For instance if your start diameter is 2.200 and the finish is 1.780 you are taking off 0.42 on the diameter or 0.21 on the radius. If your D is 0.05 you take four cuts at this depth then a final pass at 0.01 depth of cut; if you change the D to 0.051 you take only four cuts all the same depth of cut.
If you have a finish allowance with a U value (I think it is U) it is necessary to take this into account in the amount taken off on the radius.
This works on Haas machines running in Fanuc mode so I think it should work for you.
An open mind is a virtue...so long as all the common sense has not leaked out.